BLUM MINIPRESS User Manual

32
H
Drilling of line patterns
H1H2
F3
H2
H3
F 3
G 3
H 1 H 2 H 2
F 3
H 1 H 2 H 2
F 6
5 5 5
Drilling of line patterns
1. Necessary parts
• Drill bits:
one 5 mm dia. rotating clockwise
(H1) (marked black)
two 5 mm dia. rotating counter
clockwise (H2) (marked orange)
• Two cover caps (F3)
• Distance gauge for positioning stops
(H3).
• Cabinet side panel
2. Drill bit length
(see section F - point 2)
3. Change drill pattern
• Pull out fixing pin (F5) on drill head.
• At the same time, move lever (F6)
to symbol for line boring pattern
(G3).
• Make sure, fixing pin snaps back to
lock gearbox position.
4. Install drill bits
(see section F - point 4)
5. Check drilling depth adjustment
(see section F - points 5/6/7)
6. Check pneumatic brake setting
(see section F - points 8/9/10)
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English