BLUM MINIPRESS User Manual

38
K
Troubleshooting - What to do, if ...?
Fault during drilling
•Drilling depth is not
reached
•Setting of depth
adjustment bolt is
wrong
•Drilling depth gauge
swung in
•Drill shorter than
2-1/4“ (57 mm)
•Drill bits not
completely pushed
into the chucks
•Panel thickness is
different than
assumed thickness
(e. g. 9/16“ (15 mm)
instead of 5/8“
(16 mm))
•Machine hits an
object during down
stroke
•Drill / press stroke
button was released
before drilling depth
was reached
•Worktable lower than
15/16“ (24 mm)
• Check setting of the
depth adjustment
bolt
• Swing out drilling
depth gauge
• Adjust drill bit
• Clean chucks and
push drill bit
completely into the
chuck
• Check panel
thickness
• Adjust drilling depth
if necessary
• Use drilling depth
stop
• Remove object
• Press the drill stroke
button until the
drilling depth is
reached
• Build up the
worktable to
15/16“ (24 mm) height
See chapter F
F-10
See chapter F
F-9
See chapter F
See chapter F
No comments
See chapter F
See chapter F
No comments
No comments
No comments
Fault Cause of fault Eliminating fault Remarks
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English