24
F
Drilling of hinge pattern
!
!
L
D7
D2
R
13. Setting the swivel stops (D7)
• Always place operation mode
switch to set up position and
disconnect the machine from it’s
electrical source (unplugged) before
performing any work on the drill
heads, fences, stops, or pneumatic
break.
Set the swivel stops (D7) to the
required dimension and secure them.
Note:
The reading edge is on the
inside of the swivel part!
14. Place the door on the worktable
and slide it until positioned
at the stop.
Note:
For work pieces with grooves
or radii (see illus.), the stop face
can be increased by pulling the
stop lock forward.
%$0,1,35(66)$,G1US $0
To Next Page
Loading...
Need help?
General
