BLUM MINIPRESS User Manual

42
K
Troubleshooting - What to do, if ...?
No comments
No comments
Use counter-
sink bit
No comments
No comments
See section F
See section F
No comments
See section F
Fault during Hinge insertion
Fault Cause of fault Eliminating fault Remarks
•Hinges or fittings
cannot be inserted
at all, or can only
be inserted with
difficulties
•Air pressure is not
sufficient
•The insertion ram or
the swing arm is
hitting an object
•The surface of the
panel is too hard
•The drilling depth is
not deep enough
•The diameter of the
drill bits is too small
•The insertion ram is
off-set or installed
wrong
•The panel moved on
the work table before
the insertion cycle
•Shavings in holes
•Insertion ram or
swing arm is
displaced or twisted
• Adjust air pressure
to 6 bar (80-100 psi)
• Remove object from
path of insertion ram
or swing arm
• Check drilling
distance
• Countersink holes
• See point: Wrong
drilling depth
• Check drill bits and
replace if necessary
• Adjust insertion ram
• Adjust hold-down
clamps so panel
does not move
during the operation
• Check the shavings
air jet
• drill deeper,
if possible
• Adjust insertion ram
or swing arm
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English