Alarm triggering
The DWA alarm can be set off
by:
Movement sensor.
Switching on ignition with an
unauthorized motorcycle key.
Disconnection of the DWA
from the motorcycle battery
(DWA battery assumes the
power supply).
Alarm
The duration of the alarm
is 26 seconds. The system
is reactivated after another
12 seconds. A triggered alarm
can be canceled at any time by
pressing the 1 button on the
remote control. This function
does not change the state of the
anti-theft alarm system.
During the alarm, an alarm tone
sounds and the turn indicators
flash. The type of alarm sound
can be programmed.
Reason for triggering of
the alarm
After the alarm function has been
deactivated, the DWA LED indi-
cates the reason for any alarm
activation which may have oc-
curred for one minute:
1x flash: movement sensor:
motorcycle was tilted forward/
back.
2x flashes: movement sensor:
motorcycle was tilted to the
side.
3x flashes: the ignition was
turned on using an unautho-
rized key.
4x flashes: anti-theft alarm sys-
tem was disconnected from
the vehicle battery.
Note on alarm triggering
If an alarm was triggered after
the last activation of the alarm
function, then this is pointed out
with a single signal tone after the
ignition is switched on.
Deactivation
with anti-theft alarm system
(DWA)
OE
Deactivate alarm function
NOTICE
The alarm function can only be
deactivated with the ignition key
if the emergency ON/OFF switch
is in the operating position.
5
56
z
Alarm system
To Next Page
Loading...
Need help?
General
