BMW K1300R User Manual

Engage first gear.
Remove five bolts 1 from the
rear wheel, while supporting
the wheel.
If you are using the BMW
Motorrad rear-wheel stand:
remove the retaining disc.
Lower the rear wheel to the
ground and roll it out to the
rear.
If you are using the BMW
Motorrad rear-wheel stand:
reinstall the retaining disc.
Installing rear wheel
Possible malfunctions when
ABS and ASC systems in-
tervene if non-standard wheels
are installed.
See the information on the effect
of wheel size on the ABS and
ASC systems at the start of this
chapter.
Threaded fasteners not
tightened to the specified
torque can work loose or their
threads can suffer damage.
Always have the security of the
fasteners checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
If you are using the BMW
Motorrad rear-wheel stand:
remove the retaining disc.
Roll the rear wheel into position
at the rear-wheel adapter and
attach it.
If you are using the BMW
Motorrad rear-wheel stand:
reinstall the retaining disc.
Fit five bolts 1 and tighten to
the specified torque in diagon-
ally opposite sequence.
Rear wheel to wheel
flange
Tightening sequence: tight-
en in diagonally opposite se-
quence
60 Nm
8
115
z Maintenance

BMW K1300R Specifications

General

Displacement	1293 cc
Transmission	6-speed
Fuel Capacity	19 liters (5.0 US gal)
Seat Height	820 mm (32.3 in)
Bore x Stroke	80 mm x 64.3 mm
Compression Ratio	13.0:1
Fuel System	Electronic fuel injection
Final Drive	Shaft
Rear Brake	Single 265 mm disc, 2-piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	217 kg (478 lb)
Engine Type	Liquid-cooled, 4-stroke in-line four-cylinder
Power	173 hp (129 kW) at 9, 250 rpm
Torque	140 Nm at 8, 250 rpm
Weight	243 kg
Front Suspension	Duolever
Rear Suspension	Paralever
Front Brake	Dual 320 mm discs, 4-piston calipers