bora XBO User Manual

Cleaning and maintenance
EN
bora.com 79
6 Cleaning and maintenance
u Observe all safety and warning information
(see"2Safety").
Regular cleaning and maintenance ensures long service
life of the product and optimal function.
Cleaning intervals must be observed as
otherwise functions may be restricted.
u Adhere to the following cleaning cycles:
Component Cleaning cycle
Cooking chamber Intensive cleaning:
as required, after a certain period of
use (indicator on the appliance)
Drying:
when there is moisture in the oven
chamber
Food thermometer Immediately after every soiling
Appliance front Immediately after every soiling
Food supports After every use
Drain filter Immediately after every soiling
Oven chamber seal As required, after preparing poultry
Odour filter Replace yearly (indicator on appliance)
Tab.6.1
Cleaning cycles
u Never use steam cleaners, abrasive sponges,
scouring pads or chemically aggressive cleaning
agents (e.g. oven cleaner spray).
u Make sure that the cleaning agent does not contain
any sand, soda, acids, lyes or chloride.
u Do not use dishwasher tabs to replace the X BO
cleaning cartridge.
6.1 Cleaning the cooking
chamber
The interior is made entirely of stainless steel.
The appliance should be cleaned before long
periods of absence (e.g. holiday).
6.1.1 Manual cleaning
u Clean the oven chamber with a clean sponge cloth,
washing-up liquid and warm water.
u Dry the oven chamber by hand with a soft cloth.
Water must not be poured inside the oven
chamber.
6.1.2 Maintenance programmes
The appliance is equipped with an automatic cleaning
programme and a drying programme.
Intensive cleaning
The automatic cleaning programme thoroughly cleans
and descales the oven chamber with hot steam and the
environmentally friendly active ingredients in the XBO
cleaning cartridge. When using the intensive cleaning
function, the cleaning cartridge is placed in the centre
of the oven rack.
To ensure that the appliance has a long service life, an
intensive clean should be carried out every two to four
weeks, depending on frequency of use. A bar
underneath the “Intensive cleaning” symbol shows the
time remaining until the next clean is to be carried out.
An intensive clean can only be started when the
appliance has cooled to below 40 °C. Wait for
the oven to cool before inserting the cleaning
cartridge.
The cleaning time may vary due to a number of
factors (e.g. fresh water temperature, single-
phase connection).
If the power goes off during an intensive clean,
an automatic rinse will be required when the
appliance is restarted and the cleaning cartridge
must be removed.
u Remove all food supports from the oven chamber
before starting the programme.
u Remove the drain filter.
u Clean the oven rack by hand.

bora XBO Specifications

General

Brand	bora
Model	XBO
Category	Oven
Language	English