Bosch Access Easy Controller 2.1 User Manual

102 en | Appendix A How to Install & Set the TCP/IP Address on a PC Access Easy Controller 2.1
2018.11 | 1.0.6 | F.01U.122.796 Hardware Installation Manual Robert Bosch (SEA) Pte Ltd
4. If Internet Protocol TCP/IP is not found, then you need to install it. To add the TCP/IP
component, click the button, the screen below appears:
5. Highlight the Protocol line by single clicking on it, and then click the button.
6. The dialog box below appears. From this box, select Microsoft TCP/IP version 6 in the
Network Protocol window.
7. Click to proceed with the component installation. Follow any instructions
that may be displayed on the screen. Note that the system may ask you to insert your
Windows Installation Disk in the CD ROM drive. When done, go back to step 3 and select
the TCP/IP Protocol - network adapter line from the list of installed network components.
Then proceed to step. 8.

Bosch Access Easy Controller 2.1 Specifications

General

Brand	Bosch
Model	Access Easy Controller 2.1
Category	Controller
Language	English