132 en | Appendix H Resetting to Factory Default Access Easy Controller 2.1
2018.11 | 1.0.6 | F.01U.122.796 Hardware Installation Manual Robert Bosch (SEA) Pte Ltd
Warning!
All information, settings and configurations will be erased. Users are advised to do a system
backup before proceeding. (IP Address will not be reset with this function)
Click the No button to reboot the panel without changing the settings and configurations.
After setting the jumper link the system will reboot. Upon system reboot, enter the AEC2.1
URL address in the address field of a web browser.
25.2 Resetting IP Address to Default IP Address
The jumpers on the right of JP2 (vertically), when shorted with a jumper link, will reset the
panel’s IP address back to AEC2.1 default IP address (i.e 192.168.0.41). Note that this will
only reset the IP Address back to default. No information, settings and configurations will be
altered. A reboot will be required for changes to take effect. Upon completion of rebooting,
you will be able to log onto the login screen with the default IP Address.
To Next Page
Loading...
Need help?
General
