Access Easy Controller 2.1 How to Set Up the Access Easy Controller 2.1 and the Computer | en 71
Robert Bosch (SEA) Pte Ltd Hardware Installation Manual 2018.11 | 1.0.6 | F.01U.122.796
3. Follow the directions in the section of this manual entitled How to Set Initial Controller
Configuration, page 83.
Notice!
The AEC2.1 is a stand alone system and does not require a constant connection to a PC for
proper operation. The PC is used as a programming or downloading tool.
14.2 Configuring a Web Browser to Work with Access Easy
Controller 2.1
The instructions in this section describes the steps necessary to configure the Web browser to
operate with the AEC2.1. In most instances, you will not need to make any changes to the
setup of a Web browser to connect to an AEC2.1. The guidelines presented in this section are
intended for first-time browser users and as a technical reference if difficulty is encountered
when connecting with an AEC2.1.
14.3 Web Browser Set-up on a Windows Computer
Follow the steps below to configure Microsoft's Internet Explorer version 7.0 or above. Other
Web browsers are also similar.
To Next Page
Loading...
Need help?
General
