Bosch Access Easy Controller 2.1 User Manual

130 en | Appendix H Resetting to Factory Default Access Easy Controller 2.1
2018.11 | 1.0.6 | F.01U.122.796 Hardware Installation Manual Robert Bosch (SEA) Pte Ltd
25 Appendix H Resetting to Factory Default
On the first 4-Reader board of AEC2.1 system, JP2 is used to reset the panel to factory default
setting.
T12
T13
T14
T1
+
-
+
-
Fail
Tamper
Main
PWR
Earth Shield
RS485
B A
RTS
GND
RS232
TX RX
+
-
+
-
IN
OUT
DC 15V
DC 15V
T11
12V
Gnd
DO-4
D1-4
LED4
BUZ4
12V
Gnd
DO-3
D1-3
LED3
BUZ3
T10
12V
Gnd
DO-2
D1-2
LED2
BUZ2
T9
12V
Gnd
DO-1
D1-1
LED1
BUZ1
T8
COM1
NC1
NO1
COM2
NC2
NO2
T2
LED1
LED2
COM3
NC3
NO3
COM4
NC4
NO4
T3
LED3
LED4
COM5
NC5
NO5
COM6
NC6
NO6
T4
LED5
LED6
COM7
NC7
NO7
COM8
NC8
NO8
T5
LED7
LED8
In5 Gnd In6 Gnd In7 Gnd In8 Gnd
T7
In1 Gnd In2 Gnd In3 Gnd In4 Gnd
T6
4-Reader Board
BOSCH
JP2
JP1
SW2
LED9
LED10
LED11
LED12
RUN
TX
RX
CARD READ
1 2
SW1
Set IP Address back to
factory default i.e.
192.168.0.41
Resetting all the configurations and
settings back to factory default. All
the data in the panel including card
numbers and advance IO settings
will be cleared. IP Address of the
panel will remain.

Bosch Access Easy Controller 2.1 Specifications

General

Brand	Bosch
Model	Access Easy Controller 2.1
Category	Controller
Language	English