Bosch Access Easy Controller 2.1 User Manual

78 en | How to Set Up the Access Easy Controller 2.1 and the Computer Access Easy Controller 2.1
2018.11 | 1.0.6 | F.01U.122.796 Hardware Installation Manual Robert Bosch (SEA) Pte Ltd
15. After the database has been saved, the system will prompt you to reboot the controller as
shown below. Click the OK button to reboot the controller. It will now boot using the new
IP address. The controller is now ready to be connected to the customer's network.
Notice!
For detailed information on database configuration, refer to the AEC2.1 Software User
Manual.
14.4 Install AEC2.1 Certificate on a Windows Computer
Follow the steps below to install AEC2.1 certificate in Microsoft's Internet Explorer version 7.0
and above.
Note: The following steps should be followed if you are prompted with the certificate error
message, if not this step should be skipped.
1. Enter the AEC2.1's IP address in the browser's Address box as shown below.
2. This will bring up the certificate error page as shown below.

Bosch Access Easy Controller 2.1 Specifications

General

Brand	Bosch
Model	Access Easy Controller 2.1
Category	Controller
Language	English