Page 2
UN
F
O
L
D
(O
UT
)
F
O
L
D
(
IN
)
D
O
W
N
U
P
Lift Terminology
Lift model numbers with suffix
“IB” are equipped with an
automatic mechanical inboard
roll stop that also serves as the
bridge plate. Lift model num-
bers without suffix “IB” feature a
combination stationary inboard
roll stop with an independent
hinged bridge plate. Both types
of bridge plates are shown in
the illustration below for identifi-
cation purposes (details pro-
vided on page 3).
A left side (rear) pump-equipped
lift model is depicted. Right side
(front) pump lift models are a
mirrored image of left side pump
models (pump module located
on opposite end of base plate).
Details regarding lift model
variations, terminology, direction
and lift components are pro-
vided on page 3.
As viewed from outside the vehicle
Left (Rear)
Right (Front)
Outboard
Inboard
Handrails (2)
Note: Handrail shape
varies per lift model.
Pump Side Vertical Arm
Bottom
Parallel
Arms (2)
Platform Pivot Arms (2)
Rotating Pivot
Slide Arms (2)
Platform Side Plates (2)
Vertical Arm Covers (4)
Pump Side
Cylinder
Base
Plate
Hand-Held
Attendant's
Control Box
Roll Stop
Latch Foot
Roll Stop Latch
Roll Stop Cylinder
(not visible - under platform)
Opposite Pump Side Cylinder
Top Parallel Arms (2)
Adjustable Quiet-Ride Stow Block (2)
Opposite Pump Side
Vertical Arm
Towers (2)
(Upright Supports)
Automatic Outboard
Roll Stop (ARS) with
Rubber Nose Extrusion
Platform
Roll Stop
Cylinder Rod
Lift-Tite
™
Latches (2)
Unfold Assist Compression Springs (2)
Independent
Hinged
Bridge Plate
(Non-IB)
Pump Module
(Rear)
Power/Interlock
Indicator Light
Automatic Inboard Roll Stop
and
Bridge Plate (IB)
To Next Page
Loading...
Need help?
General
