Canon iR6000 Service Handbook

CHAPTER 4 SERVICE MODE
4-3
1.3 Ending Service Mode
Press the Reset key once to return to the service mode Initial screen (F05-102-01).
Press the Reset key twice to end service mode and to return to the User (standard) screen.
If you used ADJUST, FUNCTION, or OPTION in service mode, be sure to
turn off and then on the power switch after ending service mode.
1.4 Backing Up Service Mode
Each machine is adjusted before shipment from the factory, and adjustment settings are
indicated on the service label (attached to the service book case found behind the front
cover).
If you have replaced the reader controller PCB or the DC controller PCB, be sure to re-
move the EEPROM from the old PCB and mount it to the new PCB.
If you have initialized the RAM, the ADJUST and OPTION settings are replaced with the
default settings. If you have made adjustments and changed service mode settings in the
field, be sure to record the new settings on the service label. (If the label does not show an
appropriate item, make use of its blank space.)
If you want, you can print out all service mode settings at once using service mode
(COPIER>FUNCTION>MIS-P>P-PRINT).
F04-104-01 Service Label
Service Label

Canon iR6000 Specifications

General

Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan
Print Speed	60 ppm
Duplex Printing	Yes
Network Connectivity	Ethernet
Paper Sizes	A3, A4, B4, B5
Warm-Up Time	30 seconds
Multiple Copies	Up to 999
Magnification	25-400%
Copy Speed	60 ppm (A4)