LV-7292A/LV-7297A/LV-7392A/LV-7393A/LV-7398A/LV-8227A/LV-7292M/LV-7297M/LV-8227M
Expand Serial Command Functional Specifications
-33-
8.10.9 CF_LOGO Command
Command “CF_LOGO_%1_%2”[CR]
%1 “0000”-”9999” ----------------- Set LOGO PIN CODE directly
%2
“OFF” ---------------------------- Disable Logo function
“DFLT” --------------------------- Display Default Logo
“USER” -------------------------- Display Captured Logo
“UP” ----------------------- The same operation as pressing Up key or Left key
“DN” ----------------------- The same operation as pressing Down key or Right key
Details
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code “102”)
PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)
Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code “101” by receiving USER in %2 when capture has
not operated.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.10 CF_HDMISETUP Command
Command “CF_HDMISETUP_%1”[CR]
%1
“NORMAL” ----------------------- Set Normal mode
“ENHANCED” ------------------- Set Enhanced mode
Details
Set HDMI Image setup. This command is available in normal Power ON status.
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.11 CF_HDMISOUNDCommand
Command “CF_HDMISOUND_%1”[CR]
%1
“HDMI” ----------------------- Set PCM Digital Sound Inpout
“EXTERNAL” -------------- Set External sound Input
Details
Set HDMI Sound setup. This command is available in normal Power ON status.
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
To Next Page
Loading...
Need help?
General
