Advanced Guide
Troubleshooting
Contents
> Routine Maintenance >
When Printing Becomes Faint or Colors Are Incorrect
> Cleaning the Print Head
Deeply
Cleaning the Print Head Deeply
If print quality does not improve by the standard cleaning of the Print Head, clean the Print Head deeply.
Cleaning the Print Head deeply consumes more ink than the standard cleaning of the Print Head, so
clean the Print Head deeply only when necessary.
1.
Make sure that the power is turned on.
See
Operation Panel
.
2.
Clean the Print Head deeply.
(1)
Press the
Menu
button repeatedly until Maintenance appears.
(2)
Use the
(-) or
(+) button to select Deep cleaning, and press the
OK
button.
The machine starts cleaning the Print Head deeply.
Do not perform any other operations until the machine completes the deep cleaning of the Print Head. This
takes about 1 minute 30 seconds.
3.
Check the print head condition.
See
Printing the Nozzle Check Pattern
.
If the problem is not resolved, turn off the power and clean the Print Head deeply again after 24 hours. Do not
disconnect the power plug when turning off the power.
If the problem is still not resolved, replace the FINE Cartridge with a new one. See
Replacing a FINE Cartridge
.
If the problem is still not resolved, contact your service center.
Page top
Page 107 of 817 pagesCleaning the Print Head Deeply
To Next Page
Loading...
Need help?
General
