dvanced Guide
>
Faxing
>
Sending/Receiving Faxes Using the Operation Panel of the Machine
> Using the Caller ID
Service to Reject Calls
Using the Caller ID Service to Reject Calls
If you subscribe to the Caller ID service, the machine detects the sender's Caller ID. If the sender's ID
does not match the conditions specified in this setting, the machine rejects the phone call or fax
reception from the sender.
1.
Press the
FAX button, then press the
Menu
button.
The Fax settings screen is displayed.
2.
Use the button to select Reception settings, then press the
OK
button.
3.
Use the button to select Caller rejection, then press the
OK
button.
4.
Use the button to select Subscribed, then press the
OK
button.
You can now perform settings for Caller rejection.
5.
Use the button to select the phone call or fax rejection condition, then press
the
OK
button.
Set the conditions below.
Anonymous number
Selects whether to reject a phone call or fax reception from a sender with no caller identification.
Out of area
Selects whether to reject a phone call or fax reception out of the subscribed service area.
Rejected numbers
Selects whether to reject a phone call or fax reception from the numbers registered to Rejected
numbers in Fax reception reject. For details, see
Rejecting Fax Reception
.
Reject: Rejects the phone call or fax reception matching the condition specified by this setting.
If you select Reject for Rejected numbers, Register rejected no.? is displayed on the LCD. Select
Yes to register a fax/telephone number to reject. For details, see
Rejecting Fax Reception
.
ccept: Allows the phone call or fax reception matching the condition specified by this setting.
Note
This setting may not be supported depending on the country or region of purchase. Contact
your telephone company to confirm whether it provides this service.
Page top
Page 597 of 817 pagesUsing the Caller ID Service to Reject Calls
To Next Page
Loading...
Need help?
General
