36
The following icons appear on the LCD monitor.
*1 Cannot be set in , and modes.
*2 Digital Tele-Converter cannot be set.
You can combine digital zoom with optical zoom when shooting.
The available shooting characteristics and focal lengths (35mm film
equivalent) are as follows.
[Continuous] [Shoot Only] [Panning]
[Converter] setting
in Rec. menu
Reference
Page
None –
WC-DC58B
p. 140
TC-DC58C
z If you change the shooting mode to after setting [IS
Mode] to [Shooting] or [Panning] in the still image shooting
mode, the setting will change to [Continuous].
z Camera shake may not be fully corrected when shooting
with slow shutter speeds, such as with evening shots. Use
of a tripod is recommended.
z If camera shake is too strong, it may not be fully corrected.
z Hold the camera horizontally while panning (stabilization
does not work when the camera is held vertically).
Using the Digital Zoom/Digital Tele-converter
Shooting Mode
Selection Focal Length Shooting Characteristics
Standard 35 – 840 mm
Enables shooting at zoom factors of
up to 24x with digital and optical
zoom combined. can only be
set in the standard mode.
Off 35 – 210 mm
Enables shooting without digital zoom.
1.4x 49 – 294 mm
Digital zoom is fixed at the selected zoom
factor, and the focal length shifts to the
telephoto end. This enables a faster
shutter speed and less chance of camera
shake than a shot taken at the same
angle of view with [Standard] or [Off].
2.3x 80.5 – 483 mm
*
1
*
2
To Next Page
Loading...
Need help?
General
