81
Advanced Shooting Functions
Changing the Save Method for the
Original Image
When shooting still images in the Color Accent or Color Swap
mode, you can specify whether to record the original image
(the image before altering the color) in addition to the color-
altered image.
1
(Rec.) Menu [Save Original] [On]/
[Off]*.
See Menus and Settings (p. 25).
* Default setting.
z If [On] is selected, the two
images will be numbered
consecutively with the altered
image shot with the color accent
on color swap setting following the original.
When [Save Original] is Set to [On]
- Only the color accent or color swap-altered image is
shown in the LCD monitor during shooting.
- The image that appears in the LCD monitor
immediately after recording is the altered image shot
with the color accent or color swap setting. If you erase
the image at this point, the original image is erased
along with the altered image. Exercise adequate
caution before deleting an image.
- Since two images are recorded with each shot, the
number of shots remaining is approximately half the
number displayed when this function is set to [Off].
To Next Page
Loading...
Need help?
General
