48
Using the Mode Dial
The camera automatically sets the shutter speed and aperture
value to match the brightness of the subject.
z
When a correct exposure cannot be obtained, the shutter speed and
aperture values are shown in red on the LCD monitor when the shutter
button is pressed halfway. Use the following shooting methods to
obtain the correct exposure and make them show in white.
When you set the shutter speed, the camera automatically selects
an aperture value to match the brightness of the subject. Faster
shutter speeds allow you to catch an instantaneous image of a
moving subject, while slower speeds create a flowing effect and
allow you to shoot without a flash in dark areas.
z When using the control dial, the bar will be displayed and the
shutter speed can be changed.
Program AE
Shooting Mode
- Using the flash
- Changing the ISO speed
- Changing the metering method
- Setting the ND filter on
You can change the combinations of shutter speeds and
aperture values without altering the exposure (p. 69).
Setting the Shutter Speed
Shooting Mode
To Next Page
Loading...
Need help?
General
