Setting Page
111
Installation Conditions
Configure settings for camera use suitable for the location the camera will be installed.
[LED Setting]
Select whether to turn on the LED indicating the camera operation status.
Even if you set [Turn Off], the LED will light for several seconds during startup.
[Image Flip]
Select whether to vertically flip the video.
Select the setting suited to the camera installation method, such as ceiling mounting or placing on a desk.
Camera Position Control
Settings for camera use when there are no camera control restrictions for users or requests for camera control privileges.
[Restricted to Presets]
Restricts camera control of the camera angle, such as with Camera Viewer, to presets, including the home position, for
users other than administrators.
[Camera Position without Control]
Select the camera operation when there are no users with camera control privileges.
If [Return to Home Position] has been selected, the home position of the camera must be set in advance with [Camera] >
[Preset] > [Preset Registration] (P. 131).
External Input Device 1, 2
Enter each device name in order to identify the corresponding external input device being connected.
There are two external input device terminals on the camera.
[Device Name]
Enter the name of the device connected to the external input device terminal.
External Output Device 1, 2
Enter each device name in order to identify the corresponding external output device being connected.
There are two external output device terminals on the camera.
[Device Name]
Enter the name of the device connected to the external output device terminal.
R13 R12 M50
R13
H651
To Next Page
Loading...
Need help?
General
