230
Log Messages on the Camera
The list of log messages displayed in [View Logs] in [Maintenance] > [Log] > [View Logs] on the Setting Page (P. 222).
Log messages are classified into the following types.
If no content is recorded in a log for approximately two hours, “-- MARK --” will be recorded in the message area.
Error Log
System Error
S302 Error on saving settings [err]
S303 Error on saving settings [err]
S307 Error on saving settings [err]
S310 Working error in event service [err]
List of Log Messages
Category Level Code Fault level
crit Error 4xx Software-level failure (Task operations will stop)
err Error 3xx Operational error (Operations will continue)
warning Warning 2xx Non-operational error
notice Warning 1xx Error external to the system
info Information 0xx Information on normal operation
Description Can’t update system settings (S302)
Meaning An error generated while the system
was saving a setting. Setting could not
be saved.
Countermeasure Provide enough memory space by
deleting unnecessary files in the user
memory area, etc.
Description Can’t update files of system settings
(S303)
Meaning An error generated while the system
was saving a setting. Setting could not
be saved.
Countermeasure Provide enough memory space by
deleting unnecessary files in the user
memory area, etc.
Description (vbadmin.c XXX) Can’t update system
settings (S307)
Meaning An error generated while the settings
were saved by the setup protocol.
Setting could not be saved.
Countermeasure Provide enough memory space by
deleting unnecessary files in the user
memory area, etc.
Description cannot work event [%1][%2][%3]
(S310)
%1 Error number
%2 Cause of error
%3 Error information
Meaning An error occurred while the event
service was running.
Countermeasure If the problem persists after rebooting,
the camera is faulty. Arrange for
servicing.
To Next Page
Loading...
Need help?
General
