2-10
I Performing Continuous Calculations
Answer memory also lets you use the result of one calculation as one of the arguments in the
next calculation.
Example 1 w 3 =
1 w 3 s 3 =
@BU
(Continuing)BU
Continuous calculations can also be used with Type B functions (
x
2
, x
–1
, x!, on page 2-2), +, –,
^(x
y
),
x
, ° ’ ”, etc.
3. Specifying the Angle Unit and Display Format
Before performing a calculation for the first time, you should use the Setup screen to specify
the angle unit and display format.
I Setting the Angle Unit [SET UP]- [Angle]
1. On the Setup screen, highlight “Angle”.
2. Press the function key for the angle unit you want to specify, then press ).
• {Deg}/{Rad}/{Gra} ... {degrees}/{radians}/{grads}
• The relationship between degrees, grads, and radians is shown below.
360° = 2P radians = 400 grads
90° = P/2 radians = 100 grads
I Setting the Display Format [SET UP]- [Display]
1. On the Setup screen, highlight “Display”.
2. Press the function key for the item you want to set, then press ).
• {Fix}/{Sci}/{Norm}/{Eng} ... {fixed number of decimal places specification}/
{number of significant digits specification}/{normal display}/{Engineering mode}
S To specify the number of decimal places (Fix)
Example To specify two decimal places
(Fix)AU
Press the number key that corresponds to the number of decimal places you want to specify
(
n = 0 to 9).
• Displayed values are rounded off to the number of decimal places you specify.
To Next Page
Need help?
General
Weight and Dimensions
