configure the ISDN BRI interface:
Step 1 Press Return or enter yes to configure the ISDN BRI port:
Configuring interface BRI0:
Is this interface in use? [yes]
Configure IP on this interface? [yes]
IP address for this interface: 172.16.71.1
Number of bits in subnet field [0]: 8
lass B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 1
AppleTalk ending cable range [1]: 2
AppleTalk zone name [myzone]:
AppleTalk additional zone name: otherzone
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B000
In this example, routing is enabled on AppleTalk and IPX; IP has already been selected:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure LAT? [yes]: no
Configure IPX? [no]: yes
Configuring the Ethernet or Token Ring Interfaces
Take the following steps to configure the Ethernet or Token Ring interface to allow communication over a
LAN. To configure the interface parameters, you need to know the Ethernet or Token Ring interface network
addresses. In the following example, the system is being configured for an Ethernet LAN using IP.
Step 1 Respond as follows (using your own address and subnet bits) to the setup prompts:
Configuring interface Ethernet0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.72.1
Number of bits in subnet field [0]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Step 2 Enter yes if you are using AppleTalk on the interface, enter yes to configure for extended AppleTalk
networks, and then enter the cable range number. Enter the zone name, and any other additional zones that are
associated with the local zone:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (9 of 16) [10/27/2000 3:07:51 PM]
To Next Page
Loading...
Need help?
General
