Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 1
AppleTalk ending cable range [1]: 2
AppleTalk zone name [myzone]:
AppleTalk additional zone name: otherzone
AppleTalk additional zone name:
Step 3 If IPX is enabled on this interface, enter the unique IPX network number:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B001
Configure XNS on this interface? [no]
Configuring the Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to WANs through a CSU/DSU. All serial
ports on the multiport serial router are initially configured as synchronous ports. When the initial configuration
is completed, configure the serial ports you plan to use as asynchronous ports using the physical-layer
command in configuration mode. Take the following steps to configure the serial port(s):
Step 1 Enter yes to configure serial port 0:
Configuring interface Serial0:
Is this interface in use? [no]: yes
Step 2 Determine what protocols you want on the synchronous serial interface and enter the appropriate
responses:
Configure IP unnumbered on this interface? [no]: no
IP address for this interface: 172.16.73.1
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 3
AppleTalk ending cable range [3]: yes
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B000
Step 3 Configure the second synchronous serial interface:
Configuring interface Serial1:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (10 of 16) [10/27/2000 3:07:51 PM]
To Next Page
Loading...
Need help?
General
