Cisco 8841 Administration Guide

• Chassis ID TLV
• Port ID TLV
• Time to live TLV
• Port Description TLV
• System Name TLV
• System Capabilities TLV
• IEEE 802.3 MAC/PHY Configuration/Status TLV (for wired network only)
• LLDP-MED Capabilities TLV
• LLDP-MED Network Policy TLV (for application type=Voice only)
• LLDP-MED Extended Power-Via-MDI TLV (for wired network only)
• LLDP-MED Firmware Revision TLV
• End of LLDPDU TLV
The outgoing LLDPDU contains all the preceding TLVs if applicable. For the incoming LLDPDU, the
LLDPDU is discarded if any of the following TLVs are missing. All other TLVs are not validated and ignored.
• Chassis ID TLV
• Port ID TLV
• Time to live TLV
• LLDP-MED Capabilities TLV
• LLDP-MED Network Policy TLV (for application type=Voice only)
• End of LLDPDU TLV
The Cisco IP Phone sends out the shutdown LLDPDU if applicable. The LLDPDU frame contains the following
TLVs:
• Chassis ID TLV
• Port ID TLV
• Time to live TLV
• End of LLDPDU TLV
There are some restrictions in the implementation of LLDP-MED on the Cisco IP Phones:
• Storage and retrieval of neighbor information are not supported.
• SNMP and corresponding MIBs are not supported.
• Recording and retrieval of statistical counters are not supported.
• Full validation of all TLVs does not take place; TLVs that do not apply to the phones are ignored.
• Protocol state machines as stated in the standards are used only for reference.
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
54
Cisco IP Phone Installation
LLDP-MED

Cisco 8841 Specifications

General

Brand	Cisco
Model	8841
Category	IP Phone
Language	English