Cisco ASR 1001-X Installation Guide

7-3
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-02
Chapter 7 Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing and Replacing the Cisco ASR 1001-X Router Power Supplies
Figure 7-2 Removing the AC Power Supply
Step 4 Repeat these steps if it is required to remove the other AC power supply.
This completes the procedure for removing the AC power supplies from the Cisco ASR 1001-X Router.
Installing AC Power Supplies in the Cisco ASR 1001-X Router
Note Do not install the power supplies with the chassis cover off.
Follow these steps to install AC power supplies to the Cisco ASR 1001-X Router.
Step 1 At the rear of the chassis, ensure that the power switch on the chassis is in the Standby position.
Figure 7-3 shows the Cisco ASR 1001-X Router AC power supply Standby switch.
Note It is not required to place the power switch in the Standby position if you want to hot-swap a
single power supply.
372844
1
1 Retaining latch

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g