Cisco ASR 1001-X Installation Guide

5-14
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-02
Chapter 5 Cisco ASR 1001-X Router Power Up and Initial Configuration
Verifying the Initial Configuration
DETAILED STEPS
Note To aid file recovery and minimize downtime in case of file corruption, we recommend that you save
backup copies of the startup configuration file and the Cisco IOS-XE software system image file on a
server.
Note To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to NVRAM.
Verifying the Initial Configuration
Enter the following commands in Cisco IOS-XE to verify the initial configuration on the router:
• show version—Displays the system hardware version, the installed software version, the names and
sources of configuration files, the boot images, and the amount of installed DRAM, NVRAM, and
flash memory.
• show diag—Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters.
• show interfaces— Shows if interfaces are operating correctly and if interfaces and line protocols
are in the correct state, either up or down
• show ip interface brief—Displays a summary of the interfaces configured for IP protocol.
• show configuration—Helps verify if you have configured the correct hostname and password.
After you have completed and verified the initial configuration, the specific features and functions are
ready to be configured. See the Cisco ASR 1000 Series Aggregation Services Routers Software
Configuration Guide.
Powering Off the Cisco ASR 1001-X Router Safely
This section explains how to shut down the Cisco ASR 1001-X Router. We recommend that before
turning off all power to the chassis, you issue the reload command. This ensures that the operating
system cleans up all the file systems.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
Enter your password if prompted.
Step 2
copy running-config startup-config
Example:
Router# copy running-config startup-config
Saves the running configuration to the startup
configuration.

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g