EasyManuals Logo
Home>Cisco>Network Router>ASR 1001-X

Cisco ASR 1001-X Installation Guide

Cisco ASR 1001-X
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
4-7
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-02
Chapter 4 Cisco ASR 1001-X Router Installation
General Guidelines for Rack Installation
Step 7 Hold the chassis in position against the mounting rails in the equipment rack and follow these steps:
a. Insert the bottom screw into the second hole up from the bottom of the rack-mount ear and use a
hand-held screwdriver to tighten the screw to the rack rail.
Tip To make installation easier, insert one screw at the bottom of the chassis and the next screw at
the top of the chassis diagonally from the first screw.
b. Insert the top screw into the second hole from the top of the rack-mount ear diagonally from the
bottom screw and tighten the screw to the rack rail.
c. Insert the rest of the screws to secure the chassis to the rack equipment.
Step 8 Tighten all the screws on each side to secure the chassis to the equipment rack.
Note Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
(48.26 cm). The height of the chassis is 1.71 inches (4.34 cm). Airflow through the chassis is from front
to back.
This completes the procedure for installing the chassis on a two-post rack. Proceed to the Attaching a
Chassis Ground Connection” section on page 4-10 to continue the installation.
Figure 4-3 shows the Cisco ASR 1001-X Router on a two-post equipment rack.
Figure 4-3 Cisco ASR 1001-X Router Installed on a Two-Post Equipment Rack
371083

Table of Contents

Other manuals for Cisco ASR 1001-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1001-X and is the answer not in the manual?

Cisco ASR 1001-X Specifications

General IconGeneral
Product colorGray
Rack capacity1U
Rack mountingYes
Networking standards-
Ethernet LAN (RJ-45) ports6
Installed SFP modules quantity2
Flash memory1024 MB
Internal memory8192 MB
Processor cores4
AC input voltage85 - 264 V
Power source typeAC
Power consumption (typical)250 W
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 50 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)5 - 90 %
Security algorithmsAES
Weight and Dimensions IconWeight and Dimensions
Depth461.5 mm
Width439.42 mm
Height43.43 mm
Weight10590 g

Related product manuals