Configuring Diameter Thresholds ▀
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
threshold dcca-protocol-error <high_thresh> [ clear <low_thresh> ]
threshold poll dcca-protocol-error interval <seconds>
threshold monitoring ecs
end
DCCA Rating Failure Threshold
DCCA Rating Failure threshold generates alerts or alarms based on the number of times the Diameter server rejected
requests for a block of credits, due to the Rating Group (content-id) being invalid during the polling interval.
Alerts or alarms are triggered based on the following rules:
Enter condition : Actual number of rating failures > or = High Threshold
Clear condition : Actual number of rating failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
Configuring DCCA Rating Failure Threshold
To configure the DCCA Rating Failure threshold use the following configuration:
configure
threshold dcca-rating-failed <high_thresh> [ clear <low_thresh> ]
threshold poll dcca-rating-failed interval <seconds>
threshold monitoring ecs
end
DCCA Unknown Rating Group Threshold
DCCA Unknown Rating Group threshold generates alerts or alarms based on the number of times the block of credits
returned by the Diameter server is rejected due to the Rating Group being unknown during the polling interval.
Alerts or alarms are triggered based on the following rules:
Enter condition : Actual number of “unknown rating group” failures > or = High Threshold
Clear condition : Actual number of “unknown rating group” < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the
polling interval.
Configuring DCCA Unknown Rating Group Threshold
To configure the DCCA Unknown Rating Group threshold use the following configuration:
configure
To Next Page
Loading...
Need help?
General
