Cisco ASR 5000 Series Thresholding Configuration Guide

Network Address Translation Thresholds
▀ Configuring NAT Thresholds
▄ Cisco ASR 5000 Series Thresholding Configuration Guide
92
OL-25552-02
Configuring NAT Thresholds
This section describes how to enable and configure NAT thresholds.
Enabling Thresholds
To enable thresholds use the following configuration:
configure
threshold monitoring firewall
context <context_name>
threshold monitoring available-ip-pool-group
end
Notes:
The threshold monitoring available-ip-pool-group command is required only if you are configuring IP
pool thresholds. It is not required if you are only configuring NAT port-chunks usage threshold or many-to-one NAT.
Configuring Threshold Poll Interval
To configure threshold poll interval use the following configuration:
configure
threshold poll ip-pool-used interval <interval>
threshold poll nat-port-chunks-usage interval <interval>
end
Notes:
The threshold poll nat-port-chunks-usage interval command is only applicable to many-to-one NAT.
Configuring Thresholds Limits
To configure threshold limits use the following configuration:
configure
context <context_name>
threshold ip-pool-free <high_thresh> [ clear <low_thresh> ]
ip-pool-hold <high_thresh> [ clear <low_thresh> ]

Cisco ASR 5000 Series Specifications

General

Model	ASR 5000 Series
Type	Network Router
Supported Protocols	IPv4, IPv6, Diameter, GTP, and more
Power Supply	Redundant, Hot-swappable AC or DC
Cooling	Redundant, Hot-swappable fans
Management Interfaces	CLI, SNMP
Operating System	StarOS
Redundancy	Power supply, fan
Interfaces	10 Gigabit Ethernet
Applications	Mobile packet core
Port Density	Varies by model and configuration
Dimensions (H x W x D)	Varies by model
Weight	Varies by configuration
Typical Power Consumption	Varies by model and configuration