Cisco ASR 9001 Hardware Installation Guide

Using show Commands to Verify Modular Port Adapter (MPA) Status
This procedure uses show commands to verify that the new modular port adapters (MPAs) are configured
and operating correctly.
To verify the MPA status:
Procedure
Step 1
Use the show running-config command to display the system configuration. Verify that the configuration
includes the new MPA interfaces.
Step 2
Use the show diag command to display information about the installed modular line cards (MLCs).
Step 3
Use the show hw-module fpd location <rack/slot/subslot> command to verify the FPD version information
of the MPAs installed in the system.
If a modular port adapter (MPA) does not meet the minimum version required, the FPD may need
to be updated. See the Cisco ASR 9000 Series Aggregation Services Router System Management
Configuration Guide for instructions. If the update fails, the failing module is powered down and an
error message displays on the system console
Note
Step 4
Use the show platform command to check the state of all boards in the chassis, including the MLC and the
MPAs.
The MPA state should be “OK” and the MLC state should be “IOS XR RUN” in the show platform command
output.
Step 5
Use the show version command to obtain software version information for the installed MLCs as well as
interfaces available.
Using show Commands to Display Modular Port Adapter (MPA) Information
The following table describes the show commands you can use to display modular port adapter (MPA)
information.
Table 14: show Commands to Display Modular Port Adapter (MPA) Information
Type of Information ProvidedCommand
Router’s running configuration and interfaces
available in the system.
show running-config
Router’s installed linecard and modular port adapter
(MPA) type, slot, and state information.
show platform
Modular port adapter (MPA) type in that slot, number
of ports, hardware revision, part number, and
EEPROM contents.
show diag
FPD version information of modular port adapters
(MPAs) in the system.
show hw-module fpd location <rack/slot/subslot>
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
71
Installing Modules and Cables in the Chassis
Checking the Installation

Cisco ASR 9001 Specifications

General

Brand	Cisco
Model	ASR 9001
Category	Network Router
Language	English