Cisco ASR 903 Hardware Installation Guide

Change SummaryDateRevision
Added 32 T1/E1 interface module.30 November 2014OL-25178-07
Added A900 RSP2 and supported interface modules.30 July 2014OL-25178-06
Updated fan tray, power supply connector, dust filter, air
plenum.
19 November 2013OL-25178-05
Updated supported SFPs for IOS XE Release 3.10S.30 July 2013OL-25178-04
Updated supported SFPs for IOS XE Release 3.9(1).3 June 2013OL-25178-04
Updated supported SFPs for IOS XE Release 3.9.3 April 2013OL-25178-03
Updated supported SFPs for IOS XE Release 3.8.29 November 2012OL-25178-03
Added material for AC power supply, chassis air flow
information, and NEBS certification.
23 August 2012OL-25178-0
Updated supported SFPs for IOS XE Release 3.6.30 March 2012OL-25178-02
Added power draw and installation torque values.24 February 2012OL-25178-02
Initial release16 December 2011OL-25178-01
Document Audience
This guide is intended for users who are responsible for installing the Cisco router. It is intended for users
who may not be familiar with the initial configuration and troubleshooting tasks, the relationship among tasks,
or the Cisco IOS software commands necessary to perform particular tasks.
For information on general software features that are also available on other Cisco platforms, see the Cisco
IOS XE technology guide pertaining to that specific software feature.
Document Organization
This guide includes the following chapters and appendix:
DescriptionTitle
This chapter provides an overview of the Cisco ASR
903 Router.
Chapter 1, “Cisco ASR 903 Router Overview, on
page 1”
This chapter provides site preparation guidelines for
installing the Cisco ASR 903 Router.
Chapter 2, “Preparing for Installation, on page 53”
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
xii
Preface
Document Audience

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English