EasyManuals Logo
Home>Cisco>Network Router>ASR 903

Cisco ASR 903 Hardware Installation Guide

Cisco ASR 903
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
High leakage current earth connection essential before connection to system power supply. Statement
342
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning
Read the installation instructions before connecting the system to the power source. Statement 1004Warning
This product relies on the buildings installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated for 550 W DC Power Supply (PID A900-PWR550-D and A900-PWR550-D-E):
For a -48/-60 VDC installation, the wire shall be 12 AWG minimum with a 20 A circuit breaker. For a
24 VDC installation, the wire shall be 8 AWG minimum with a 40 A branch circuit breaker. Statement
1005
Warning
This product relies on the buildings installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated for 1200 W DC Power Supply (PID A900-PWR1200-D): For a -48/-60 VDC
installation, the wire shall be 10 AWG minimum with a 50 A circuit breaker. Statement 1005
Warning
This product relies on the buildings installation for short-circuit (overcurrent) protection. For an AC
installation, ensure that the branch circuit breaker is rated a maximum 20A.
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturers instructions. Statement 1015
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018Warning
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
58
Preparing for Installation
Safety with Electricity

Table of Contents

Other manuals for Cisco ASR 903

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 903 and is the answer not in the manual?

Cisco ASR 903 Specifications

General IconGeneral
BrandCisco
ModelASR 903
CategoryNetwork Router
LanguageEnglish

Related product manuals