Cisco Catalyst 3650 Series Configuration Guide

CHAPTER 3
Configuring WLANs
•
Finding Feature Information, page 21
•
Prerequisites for WLANs, page 21
•
Restrictions for WLANs, page 22
•
Information About WLANs, page 23
•
How to Configure WLANs, page 27
•
Monitoring WLAN Properties (CLI), page 44
•
Viewing WLAN Properties (GUI), page 45
•
Where to Go Next, page 45
•
Additional References, page 45
•
Feature Information for WLANs, page 46
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release. To find information
about the features documented in this module, and to see a list of the releases in which each feature is supported,
see the Feature Information Table at the end of this document.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for WLANs
•
You can associate up to 16 WLANs with each access point group and assign specific access points to
each group. Each access point advertises only the enabled WLANs that belong to its access point group.
The access point (AP) does not advertise disabled WLANs in its access point group or WLANs that
belong to another group.
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
OL-32353-01 21

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English