Cisco Catalyst 3650 Series Configuration Guide

Switch(config)# ip dhcp snooping trust
Switch(config)# ip dhcp snooping trust
Related Topics
Configuring DHCP for WLANs (CLI), on page 52
Configuring Advanced WLAN Properties (GUI), on page 39
Information About the Dynamic Host Configuration Protocol, on page 48
Internal DHCP Servers, on page 49
External DHCP Servers, on page 49
DHCP Assignments, on page 50
Information About DHCP Option 82, on page 51
Configuring DHCP Scopes, on page 51
Information About DHCP Scopes, on page 52
Restrictions for Configuring DHCP for WLANs
•
If you override the DHCP server in a WLAN, you must ensure that you configure the underlying Cisco
IOS configuration to make sure that the DHCP server is reachable.
•
WLAN DHCP override works only if DHCP service is enabled on the switch.
You can configure DHCP service in the following ways:
◦
Configuring the DHCP pool on the switch.
◦
Configuring a DHCP relay agent on the SVI. Note: the VLAN of the SVI must be mapped to the
WLAN where DHCP override is configured.
Related Topics
Configuring DHCP for WLANs (CLI), on page 52
Configuring Advanced WLAN Properties (GUI), on page 39
Information About the Dynamic Host Configuration Protocol, on page 48
Internal DHCP Servers, on page 49
External DHCP Servers, on page 49
DHCP Assignments, on page 50
Information About DHCP Option 82, on page 51
Configuring DHCP Scopes, on page 51
Information About DHCP Scopes, on page 52
Information About the Dynamic Host Configuration Protocol
You can configure WLANs to use the same or different Dynamic Host Configuration Protocol (DHCP) servers
or no DHCP server. Two types of DHCP servers are available: internal and external.
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
48 OL-32353-01
Configuring DHCP for WLANs
Restrictions for Configuring DHCP for WLANs

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English