Cisco IE-3000-8TC User Manual

10-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 10 Configuring SDM Templates
.Displaying the SDM Templates
Setting the SDM Template
Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
After the system reboots, you can use the show sdm prefer privileged EXEC command to verify the new
template configuration. If you enter the show sdm prefer command before you enter the reload
privileged EXEC command, the show sdm prefer command shows the template currently in use and the
template that will become active after a reload.
.Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | dual-ipv4-and-ipv6 default | qos] privileged EXEC command to
display the resource numbers supported by the specified template.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
sdm prefer {default | dual-ipv4-and-ipv6
default | qos}
Specify the SDM template to be used on the switch:
The keywords have these meanings:
• default—Gives balance to all functions.
• dual-ipv4-and-ipv6 default—Allows the switch to be used in
dual stack environments (supporting both IPv4 and IPv6).
• qos—Maximizes system resources for QoS ACEs.
Use the no sdm prefer command to set the switch to the default
template.
The default template balances the use of system resources.
Step 3
end Return to privileged EXEC mode.
Step 4
reload Reload the operating system.

Cisco IE-3000-8TC Specifications

General

Brand	Cisco
Model	IE-3000-8TC
Category	Switch
Language	English