Cisco IE-3000-8TC User Manual

C-1
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
APPENDIX
C
Unsupported Commands in
Cisco IOS Release 12.2(50)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the IE 3000 switch prompt but are not supported in this release, either because they
are not tested or because of switch hardware limitations. This is not a complete list. These unsupported
commands are listed by software feature and command mode:
• Access Control Lists, page C-1
• Boot Loader Commands, page C-2
• Debug Commands, page C-2
• |IGMP Snooping Commands, page C-2
• Interface Commands, page C-3
• MAC Address Commands, page C-3
• Miscellaneous, page C-4
• Network Address Translation (NAT) Commands, page C-4
• QoS, page C-4
• SNMP, page C-5
• SNMPv3, page C-5
• Spanning Tree, page C-6
• VLAN, page C-6
• VTP, page C-6
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]

Cisco IE-3000-8TC Specifications

General

Brand	Cisco
Model	IE-3000-8TC
Category	Switch
Language	English