Cisco RV132W Command Line Interface Reference Guide

4
Cisco RV34xx Router CLI Reference Guide 22
Configuration Commands
The CLI configuration commands allow users to configure, monitor and maintain
the router. All CLI configuration commands are listed in this chapter:
dhcpserver
The dhcpserver commands allow network devices to automatically obtain a valid
IP address from a server. All the dhcpserver commands are listed here:
• dhcpserver config
vlanID start-IP-address end-IP-address leased-time
default-gateway-IP-address
• dhcpserver reserving {add | delete} vlanID description IP-address MAC-
address
• dhcpserver show vlan X
dhcpserver config vlanID start-IP-address end-IP-address
leased-time default-gateway-IP-address
To configure the dhcpserver, use the dhcpserver config vlanID start-IP-address
end-IP-address leased-time default-gateway-IP-address command
.
Parameters
vlanID - Enter the vlan ID
start-IP-address - Enter the start IP address
end-IP-address - Enter the end IP address
leased-time (hour) - Enter the leased time in hours
default-gateway-IP-address - Enter the default gateway IP address

Cisco RV132W Specifications

General

Brand	Cisco
Model	RV132W
Category	Network Router
Language	English