In the Connection Table, you can add, edit, delete, or refresh a tunnel. You can also click on Column Display
Selection to select the column headers displayed in the Connection Table.
GRE Tunnel Status
The Connection Table displays the following:
• Interface Name – Name of the interface.
• IP Address – IP address of the GRE tunnel.
• Source – The source of the GRE tunnel.
• Destination – Destination of the GRE tunnel.
• Enable – Enable the GRE tunnel.
• Status – Status of the GRE tunnel.
Client-to-Site VPN Status
In this mode, the client from Internet connects to the server to access the corporate network/LAN behind the
server. For a secure connection, you can implement a client-to-site VPN. You can view all the Client-to-Tunnel
connections, add, edit, or delete the connections in the Connection Table.
The Connection Table displays the following:
• Group/Tunnel Name - Name of the VPN tunnel. This is for reference purposes only and does not match
the name used at the other end of the tunnel.
• Connections – Status of the connection.
• Phase2 Enc/Auth/Grp – Phase 2 encryption type (NULL/DES/3DES/AES-128/AES-192/AES-256),
authentication method (NULL/MD5/SHA1), and DH group number (1/2/5).
• Local Group – IP address and subnet mask of the local group.
• Action –Action status.
OpenVPN Status
OpenVPN is an open software application that implements VPN techniques for creating secure point-to-point
or site-to-site connections in routed or bridged configurations and remote access facilities. Here, you can view
the status of the OpenVPN.
The Connection Table shows the status of the OpenVPN. You can also add edit or delete connections.
• Session ID – Session identification.
• User – Name of user.
• Client IP (Actual) – Actual client IP address.
• Client IP (VPN) – Client VPN IP address.
• TX Bytes – Number of TX bytes.
• RX Bytes – Number of RX bytes.
RV260x Administration Guide
19
Status and Statistics
VPN Status
To Next Page
Loading...
Need help?
General
