Step 7 Click Apply.
Multi-WAN
WAN failover provides efficient utilization of multiple WAN interfaces. Based on the configuration, this
feature can be used to distribute traffic among the interfaces. The Multi-WAN feature provides the outbound
WAN traffic over multiple WAN interfaces (WAN & USB) based on a numeric weight assignment. It also
monitors each WAN connection using repeated ping tests and automatically routes outbound traffic to another
WAN interface if connectivity is lost. The specific outbound traffic rules can also be configured because of
5-tuple of a connection. The VLAN interfaces of WAN can also be configured for load balance or failover.
To configure the multi WAN settings, follow theses steps:
Step 1 Select WAN > Multi-WAN.
Step 2 In the Interface Setting Table, configure the following for each interface:
• Precedence (for Failover) – Enter the priority value for the interface to bring up another connection on another
interface.
Step 3 In The Action column, click Advanced Configuration and configure the following:
a) Check Enable Network Service Detection to allow the device to detect network connectivity by pinging specified
devices and enter the settings as described here.
• Retry Count – Number of times to ping a device. The range is 1 to 10 and the default is 3.
• Retry Timeout – Number of seconds to wait between the pings. The range is 1 to 300 and the default is 5
seconds.
• Detect Destination – Select Default Gateway or Remote Host – If choosing the remote host, enter the host.
Step 4 Click Apply.
Mobile Network
A mobile broadband modem is a type of modem that allows a laptop, a personal computer, or a router to
receive Internet access using a mobile broadband connection instead of using phone or cable lines.
To configure the Mobile Network, follow these steps:
Step 1 Select WAN > Mobile Network.
Step 2 The Port setting is set to the default setting of USB.
Step 3 Click Enable to enable the port.
Step 4 In the Card Status section, click Connect to establish the connection.
Step 5 In the Service Type section, select a service type option from the drop-down list.
RV260x Administration Guide
50
WAN
Multi-WAN
To Next Page
Loading...
Need help?
General
