Check to enable MPPE encryption.MPPE Encryption
If the IPv4 uses L2TP to connect, configure the following:
For DCHP, select this option to enable DHCP to provide an IP address. For Static IP,
select this option and provide an IP address, netmask, and the IP address of the default
gateway.
IP Assignment
Enter the name of the server.L2TP Server IP/FQDN
The username assigned to you by the ISP.Username
The password assigned to you by the ISP.Password
Check to display the password.Show Password
Select Use L2TP Provided DNS Server or Use DNS.DNS Server
Enter the IP address of the primary and or secondary Static DNS in the fields.Static DNS 1 & 2
Select Connection on Demand if your ISP charges when connected. Enter the maximum
idle time, in seconds, to wait before terminating the connection due to inactivity. Default
is 5 minutes.
Connection on Demand
Select Keep Alive to periodically check the connection, and to re-establish the connection
when it is disconnected.
Keep Alive
Select the authentication type from the drop-down list (Auto Negotiation, PAP, CHAP,
MS-CHAP, MS-CHAPv2).
Authentication Type
If the IPv6 Uses SLAAC to Connect
In the SLAAC Settings section, enter the following information:
Enter the IP address of the primary and or secondary Static DNS.Static DNS 1 & 2
Check to enable and enter a prefix name.DHCP-PD (IPv6 only)
Step 5 Click Apply.
For Advanced Settings
Step 6 Click the Advanced Settings tab and configure the following:
Check to enable the WAN VLAN tag.WAN VLAN Tag
Enter the VLAN ID.VLAN ID
Select Auto to set the size automatically. To set the MTU
size manually, select Manual and enter the MTU size. (The
size in bytes of the largest protocol data unit that the layer
can pass.).
MTU– Maximum Transmission Unit
Check MAC Address Clone and enter the MAC address.
Click Clone My PC’s MAC to use the MAC address of
your computer as the clone MAC address for the device.
MAC Address Clone
When MAC Address Clone is enabled, the port mirroring does not work.
Note
RV260x Administration Guide
49
WAN
WAN Settings
To Next Page
Loading...
Need help?
General
