EasyManuals Logo
Home>Cisco>Network Router>RV260 series

Cisco RV260 series User Manual

Cisco RV260 series
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
Select the advertisement mode from the drop-down list.
Unsolicited Multicast Sends Router Advertisement messages to all interfaces in
the multicast group. Enter the Advertisement Interval. This option is the default
setting.
Unicast Send Router Advertisement messages only to well-known IPv6 addresses.
Advertisement Mode
Enter the time interval between 10 and 1800 (Default is 30 seconds) at which the router
advertisement messages are sent.
Advertisement Interval
Determines whether hosts can use DHCPv6 to obtain IP addresses and related information.
Check one of the following:
Managed Hosts use an administered, stateful configuration protocol (DHCPv6)
to obtain stateful addresses and other information through DHCPv6.
Other Uses an administered, stateful configuration protocol (DHCPv6) to obtain
other, non-address information, such as DNS server address.
RA Flags
Preference metric used in a network topology where multi-homed hosts have access to
multiple routers. Router Preference helps a host to choose an appropriate router. There
are three preferences to choose from, such as High, Medium, or Low. The default setting
is High. Select the preference from the drop-down list.
Router Preference
Maximum Transmission Unit (MTU) is the size of the largest packet that can be sent
over the network. MTUs are used in Router Advertisement messages to ensure that all
nodes on the network use the same MTU value when the LAN MTU is unknown. The
default setting is 1500 bytes, which is the standard value for Ethernet networks. For
PPPoE connections, the standard is 1492 bytes. Unless your ISP requires a different
setting, this setting should not be changed. Enter a value between 1280 and 1500.
Maximum Transmission
Unit (MTU)
Time in seconds that the Router Advertisement messages exist on the route. Enter time
in seconds. The default is 3600 seconds.
Router Lifetime
Step 3 In the Prefix Table, click Add or Edit to add or edit a subnet and enter an IPv6 address, Prefix Length, and Lifetime.
Step 4 Click Apply.
RV260x Administration Guide
62
LAN
Router Advertisement

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV260 series and is the answer not in the manual?

Cisco RV260 series Specifications

General IconGeneral
BrandCisco
ModelRV260 series
CategoryNetwork Router
LanguageEnglish

Related product manuals