Cisco SE-CL-L3 User Manual

APPENDIX B
Storage Controller Considerations
This appendix provides storage controller (RAID and HBA) information.
• Supported Storage Controllers and Cables, on page 91
• Storage Controller Card Firmware Compatibility, on page 92
• RAID Backup (Supercap), on page 92
• Write-Cache Policy for Cisco 12G SAS Modular RAID Controller, on page 92
• Mixing Drive Types in RAID Groups, on page 93
• RAID Controller Migration, on page 93
• Storage Controller and Backplane Connectors, on page 94
• Embedded SATA RAID Controller, on page 96
• For More RAID Utility Information, on page 99
Supported Storage Controllers and Cables
This server supports a single, PCIe-style, SAS RAID or HBA controller that plugs into a dedicated internal
riser. Alternatively, the server has a software-based SATA RAID controller embedded in the system.
Do not mix controller types in the server. Do not use the embedded SATA controller and a hardware-based
RAID controller card at the same time. This combination is not supported and could result in data loss.
Note
NVMe PCIe SSDs cannot be controlled by a SAS/SATA RAID controller.
Note
This server supports the RAID and HBA controller options and cable requirements shown in the following
table.
Required CablesOptional
Supercap
Backup?
RAID
Levels
Server Version/Maximum Drives
Controlled
Controller
Cisco Application Services Engine Hardware Installation Guide
91

Cisco SE-CL-L3 Specifications

General

Brand	Cisco
Model	SE-CL-L3
Category	Server
Language	English