Administration
File Management
71 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
5
• Description—Enter a server description.
• Minimum Severity—Select the minimum level of system log messages to be sent to
the server.
STEP 5 Click Apply. The Add Remote Log Server page closes, the SYSLOG server is added, and the
Running Configuration file is updated.
File Management
See Administration: File Management.
Reboot
Some configuration changes, such as enabling jumbo frame support, require the system to be
rebooted before they take effect. However, rebooting the device deletes the Running
Configuration, so it is critical that the Running Configuration is saved to the Startup
Configuration before the device is rebooted. Clicking Apply does not save the configuration to
the Startup Configuration. For more information on files and file types, see the System Files
section.
You can back up the device configuration by using the File Operations page or clicking Save
at the top of the window. You can also upload the configuration from a remote device in the
same page.
You might want to set the time of the reboot for some time in the future. This could happen, for
example, in one of the following cases:
• You are performing actions on a remote device, and a mistake in these actions might
create loss of connectivity to the remote device. Pre-scheduling a reboot restores the
working configuration and enables restoring the connectivity to the remote device after
the specified time expires. If these actions are successful, the delayed reboot can be
manually cancelled.
• Reloading the device cause loss of connectivity in the network, thus by using delayed
reboot, you can schedule the reboot to a time that is more convenient for the users (e.g.
late night).
To Next Page
Loading...
Need help?
General
