Cisco SPA112 Administration Guide

Configuring the Voice Settings
Line1 and Line 2 Settings (PHONE Port1 and PHONE2)
Cisco SPA100Series Administration Guide 83
4
Line 1 and Line 2 Settings (PHONE Port1 and PHONE2)
Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for
calls through the PHONE 1 and PHONE2 ports.
or Line 2 Enter the settings as described below. After making changes, click
Submit to save your settings, or click Cancel to redisplay the page with the saved
settings.
NOTE In a configuration profile, the FXS parameters must be appended with the
appropriate numeral (for example, [1] or [2]) to identify the port to which the setting
applies.
Line Enable
Streaming Audio Server (SAS)
Force G722 Code Dial prefix to make G.722 the only codec that can be used
for the call.
Default setting: *02722
Field Description
Field Description
Line Enable To enable this line for service, select yes. Otherwise,
select no.
Default setting: yes
Field Description
SAS Enable To enable the use of the line as a streaming audio source,
select yes. Otherwise, select no. If enabled, the line cannot
be used for outgoing calls. Instead, it auto-answers
incoming calls and streams audio RTP packets to the
caller.
Default setting: no

Cisco SPA112 Specifications

General

Supported network protocols	IPv4, IPv6, ARP, DNS, SRV, DHCP, PPPoE, ICMP, TCP, UDP, RTP, RTCP, SNTP
DHCP client	Yes
VPN support	802.1p
Security algorithms	SSL/TLS
Authentication method	SIP
Modem (RJ-11) ports	2
Ethernet LAN (RJ-45) ports	1
Voice codecs	G.711, G.726, G.729
Certification	FCC, CE, ICES, A-Tick, RoHS, UL
Fax compatibility	T.38
Output current	2 A
Output voltage	5 V
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	101 mm
Height	28 mm
Weight	153 g