D-Link DSL-226 User Manual

35D-Link DSL-226 User Manual
Section 4 - Conguration
Connection Types
Connection Type: Dynamic IP (DHCP)
Select Dynamic IP Address (DHCP) to obtain an IP address automatically
from your ISP. Select this option if your ISP does not provide you with a specic
IP address.
IPv4 Settings
Connection:
Select Dynamic IP Address (DHCP).
Protocol:
Select IPv4, IPv6 or IPv4/IPv6 for both IPv4 and IPv6 addressing
mechanism. If you choose IPv6, refer to the below IPv6 Settings.
Connection Type:
Select Bridged IP LLC, Bridged IP VC-Mux, Routed IP LLC, or Routed
IP VC-Mux as the encapsulation method. This is only available for
ADSL.
Advanced Settings
MTU:
Maximum Transmission Unit (576-1516) - you may need to change
the MTU for optimal performance with your ISP. The default is 1492.
Usage:
Select None or Default Route to use this WAN connection type as the
default route.
NAT Enable:
Network address translation (NAT) translates private IP addresses to
public IP addresses prior to allowing private IP networks to connect
to the public network.
Enable PPPoE
Passthrough
Enable or disable PPPoE trac to pass through this VC conguration.
It allows hosts behind the router to establish a PPPoE connection to
an external server.

D-Link DSL-226 Specifications

General

Brand	D-Link
Model	DSL-226
Category	Network Router
Language	English