D-Link DSL-G225 User Manual

43D-Link DSL-G225 Wireless N300 ADSL2+/VDSL2 Modem Router User Manual
Section 4 - Conguration
Interface Group: Select the interface group used locally by the router. Leave this as
the default if you are not sure.
Router IP Address: Enter the IP address of the router. The default IP address is 192.168.1.1.
Note: If you change the IP address, once you click Apply you will need
to enter the new IP address in your browser in order to access the
conguration utility.
Subnet Mask: Enter the subnet mask. The default subnet mask is 255.255.255.0.
Configure
the second IP
Address...:
If you wish to add another IP address to use to configure the router,
check this box and enter the IP address and subnet mask.
ROUTER SETTINGS
Local Network
This optional section allows you to congure the local network and DHCP settings of your device. The DHCP service supplies IP
settings to clients congured to automatically obtain IP settings that are connected to the device through the Ethernet port.
Enable/Disable
DHCP Server:
By default, DHCP is enabled. You can disable DHCP if required.
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
DHCP Lease Time: Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may experience an IP address conflict.
Click Apply when you are done.
DHCP SERVER SETTINGS OPTIONAL

D-Link DSL-G225 Specifications

Power

input voltage	100~240 V
input frequency	50~60 Hz
output voltage	DC 12 V

Operating Environment

operating temperature	0 to 40 °C
non-operating temperature	-20 to 65 °C
operating humidity	0% - 90% non-condensing

Weight and Dimensions

dimensions	131.5 x 74.3 x 185.4 mm
weight	285 grams