xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
519
Example
To display the IGMP configuration for all interfaces:
DGS-3620-28SC:admin#show igmp
Command: show igmp
IGMP Interface Configurations
Interface IP Address/Netmask Ver- Query Maximum Robust- Last State
sion Response ness Member
Time Value Query
Interval
------------ ------------------ ---- ------ -------- ------- -------- --------
System 10.90.90.90/8 3 125 10 2 1 Disabled
Total Entries: 1
41-3 show igmp group
Description
This command is used to display the switch’s IGMP group table.
Format
show igmp group {group <group> | ipif <ipif_name 12>}
Parameters
group - (Optional) Specifies the multicast group ID.
<group> - Enter the multicast group ID value here.
ipif - (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
all - Specifies that all the IP interfaces will be used.
If no parameter is specified, the system will display all IGMP group tables.
Restrictions
None.
Example
To display the IGMP group table:
DGS-3620-28SC:admin# show igmp group
Command: show igmp group
Interface Multicast Group Last Reporter IP Querier IP Expire
------------ --------------- --------------- ------------------- ---------
System 224.0.1.24 10.18.1.3 10.48.74.122 259
To Next Page
Loading...
Need help?
General