xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
75
is no time out. The default value is 30 seconds.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure 60 seconds for user to input:
DGS-3620-28SC:admin#config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
4-25 config authen parameter attempt
Description
This command is used to configure the maximum attempts for users trying to login or promote the
privilege on console, Telnet, or SSH applications. If the failure value is exceeded, connection or
access will be locked.
Format
config authen parameter attempt <int 1-255>
Parameters
<int 1-255> - Enter the amount of attempts for users trying to login or promote the privilege on
console, Telnet, or SSH. The default value is 3.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the maximum attempts for users trying to login or promote the privilege to be 9:
DGS-3620-28SC:admin#config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
To Next Page
Loading...
Need help?
General